Modern Mining October 2019

HEALTH AND SAFETY IN MINING

Jet Demolition secures redundant mine shafts R edundant mine shafts are becoming a growing risk for large mining houses due to a sharp spike in illegal mining activities. Demolition specialist Jet

Demolition is offering a turnkey service that provides an effective solution to the problem. “The fact is that illegal mining is born from desperation. People are willing to risk their lives by going underground to try and recover pockets of unmined mate- rial, as well as copper cable and steel shaft infrastructure. They can be armed, which poses a huge risk. It is not uncommon to witness extreme violence or intimidation in these areas,” says Jet Demolition Contracts Manager André Botes. The most effective way of ensuring that redundant shafts are protected from occupation by illegal miners is to seal them permanently below natural ground level (NGL), typically after filling the shaft bar- rel. This is where Jet Demolition can play a vital role. Its turnkey service offering for the mining industry includes backfilling shaft barrels, designing permanent caps, installing caps at a defined depth below NGL, and record- ing the final position and depth of caps, followed by the backfill and reinstatement of the natural material over cap tops. Mining houses typically require such a turnkey service for two main scenarios: firstly, to seal the shaft permanently as a mitigating factor, thereby preventing unauthorised access by illegal miners or, secondly, to rehabilitate the mining footprint fully, rendering the area safe for public use. feature

Installed rebar cage ready for concreting.

the approved Environmental Management Plan, as well as any client-specific requirements. The natural surrounding environment also has to be taken into account, paying special attention to natural water courses and stormwater management. This could mean rerouting natural water courses slightly, while ensuring there is no sub- sequent negative downstream effect. All material used to fill shafts must be clean and uncontaminated. This is vital to ensure that no groundwater contamination will occur after sealing. “We have also sealed a few shafts that had to be equipped with monitoring access points as part of the Acid Mine Drainage (AMD) project in the Western, Central and Eastern basins of the Witwatersrand Goldfields. These access points will be used to monitor the quality and volume of subsurface water in the foreseeable future,” notes Botes. Jet Demolition pays particular atten- tion to health and safety, especially when working over an open shaft that could extend a few kilometres underground. “It is absolutely critical to protect plant and per- sonnel from falling,” Botes stresses. Hence certified lifelines are installed prior to any work commencing, providing personnel with anchoring points during shaft sealing. Larger machines are also typically used for increased reach. 

Another challenge is that various shafts are often interconnected, such as a live shaft and a redundant shaft linking together hundreds of metres below NGL. “It is thus critical to ensure that we understand the network we are operat- ing within, so that our capping and sealing activities do not influence or adversely affect miners underground in a neighbour- ing shaft,” Botes stresses. The main requirement for permanent shaft sealing and capping projects is to ensure full compliance with the Mine Health and Safety Act, and the provisions of the Department of Mineral Resources,

Positioning of precast concrete cap sections over a shaft.

40  MODERN MINING  October 2019